Determinants of natural zeolite clinoptilolite adsorption capacity for removing NO2

AUTHORS

Nabiollah Mansouri 1 , Mohammad reza Massoudinejad 2 , * , Hasan Asilian 3 , Azadeh Mafreshi 1

1 Dept. of Environmental Engineering, School of Environmental and Energy, Science and Research Branch, Islamic Azad University, Tehran, Iran

2 Dept. of Environmental Health, School of Health, Shahid Beheshti University of Medical Sciences, Tehran, Iran

3 Dept. of Accupational Health, School of Medicine, Tarbiat Modares University, Tehran, Iran

How to Cite: Mansouri N, Massoudinejad M R, Asilian H, Mafreshi A. Determinants of natural zeolite clinoptilolite adsorption capacity for removing NO2, J Kermanshah Univ Med Sci. 2010 ; 14(3):e79472.

ARTICLE INFORMATION

Journal of Kermanshah University of Medical Sciences: 14 (3); e79472
Published Online: December 19, 2010
Article Type: Research Article
Received: November 02, 2009
Accepted: March 09, 2010

Crossmark

CHEKING

READ FULL TEXT
Abstract

Background: NO2 is a poisonous gas that potential to cause major threat to human being health and the environment, as a result, removing this gas from environment seems to be essential.

Methods: The study aimed to remove this gas from environment using Iranian natural zeolite, clinoptilolite. After crushing and preparing two sizes of 1 and 2 mm zeolite they were activated in 380 to 420 ºC for 20 minutes. NO2 was produced by reaction of copper (Cu) and nitric acid (HNO3) and diluted with enough air to achieve desired concentration. A laboratory reactor set with different concentration of NO2 (20, 30, and, 45 ppm), flows through the zeolite absorbent bed was prepared. Different parameters affected No2 absorption, such as concentration, height, and diameter of zeolite bed, zeolite granulation, and activation temperature were examined.

Results: In different condition, the adsorption range of the zeolite for NO2 was varied from  0.35% W for 2mm granulation and the 20 ppm concentration to 1.5% W using 1mm granulation and 45 ppm concentration of NO2. Activation temperature of 420 ºC for 20 min was the best condition removing NO2. Efficiency of 1mm granulation was higher than 2mm.

Conclusion: Reducing parameters such as height and diameter of zeolite bed decreased but increasing concentration of gas flow increased adsorption capacity of zeolite. Using Iranian zeolite in gas masks still not recommended.

Keywords

nitrogen dioxide clinoptilolite zeolite granulation adsorption capacity

© 2010, Journal of Kermanshah University of Medical Sciences. This is an open-access article distributed under the terms of the Creative Commons Attribution-NonCommercial 4.0 International License (http://creativecommons.org/licenses/by-nc/4.0/) which permits copy and redistribute the material just in noncommercial usages, provided the original work is properly cited.

Fulltext

References

  • 1.

    The references of this article is available on PDF

  • COMMENTS

    LEAVE A COMMENT HERE: